Communicating Design Intent to Fabricators

Altium Designer

| Created: August 3, 2020

Communicating design intent to the fabricator is one of the most critical steps in the product development flow as it can impact your ability to construct a product correctly and quickly the first time. During this webinar, you'll sharpen your knowledge about how to effectively document, and communicate design information to fabricators, allowing for rapid volume production of a product without design re-spins, complex email chains, or numerous phone calls.

About Author

About Author

PCB Design Tools for Electronics Design and DFM. Information for EDA Leaders.

More content by Altium Designer

Recent Articles

Pin-Package Delay and Via Delay

Pin-Package Delay and Via Delay in High Speed Length Tuning Take a look at the inside of some integrated circuit packages, and you’ll find a number of wires bonded to the semiconductor die and the pads at the edge of the component's package. As a signal traverses makes its way along an interconnect and into a destination circuit, signals need to travel across these bond wires and pads before they are interpreted as a logic state. As you look around the edge of an IC, these bond wires can have different Read Article

Making Codes Tangible Through Electronic Projects

Making Codes Tangible Through Electronic Projects In this episode, Bill Kolicoski, the creator of Taste the Code Youtube channel, inspires young electronic designers to start learning through creating. Read Article

Rapidly Creating New Designs And Reusing Existing Ones It's no secret that software developers often use completed code fragments from other projects for quick and predictable results. The Watch Video

SAP (Semi-Additive PCB Process) – Top 5 Questions Regarding Stack Up

SAP (Semi-Additive PCB Process) – Top 5 Questions Regarding Stack Up This blog addresses commonly asked questions related to circuit layer stack up in relation to the new technology of SAP (Semi-Additive PCB Process). Read Article

Landing a Full-Time Engineering Career at NASA

Landing a Full-Time Engineering Career at NASA Andrew Hartnett dreamt of working with NASA at a very young age. He will share with us exactly how he landed his Computer Engineer position in this very sought-after agency. Watch this episode, or listen on the go! Read Article

Ebook: Guide to Using Ferrite Beads in a PCB Ferrite beads in a PCB are the stuff of myth, but there are legitimate uses for ferrite beads and other ferrite components. In this e-book, we’ll examine some uses of ferrite beads in a PCB, as well as other magnetics. Download PDF

US PCB Manufacturing

US Congress Proposes Support for American PCB Manufacturing Meet the Supporting American Printed Circuit Boards Act of 2022, proposed in the US Congress by Reps. Moore and Eshoo. Read Article

A-SAP™ – What do you need to know?

A-SAP™ – What do you need to know? Semi-additive process or SAP allows the ability to design with, and manufacture a 15-micron trace and space repeatedly and reliably. Read more about this great option and opportunity previously not available to PCB designers and PCB fabricators. Read Article

Stop Surprises By Assuring Your BOM Is Always Up To Date The electronics industry is constantly changing, especially when it comes to the supply chain. Components are constantly going out of Watch Video

Monte Carlo Simulation vs. Sensitivity Analysis

Monte Carlo Simulation vs. Sensitivity Analysis: What’s the Difference? SPICE gives you an alternative to Monte Carlo analysis so that you can understand circuit sensitivity to variations in parameters. Read Article

Back to Home