Bill of Materials Management Guide

Created: March 19, 2018
Updated: March 20, 2020

Download the PDF to keep learning offline

In the past, many PCB designers were confined to tools that dictated when the Bill of Materials could be produced. But we know from years of experience that the Bill of Materials, or BOM, can change throughout the design process. We believe the decision should be up to you, which is why we strive to offer tools that embrace flexible and agile options for PCB designers and other professionals involved in the decision process.

Click the PDF above to read more about Bill of Materials Management Guide in this Ebook. Or read the original, full-length content here:

Check out the Bill of Materials Management Presentation for a more concise version of this material.

most recent articles

Reduce CM Noise in Your Power Supply with Impedance Balancing You can use impedance balancing to reduce conducted common-mode noise in your power supply. Here’s how it works and some experimental results. Read Article

Using Altium 365 for Sharing Simulations in the Cloud Altium 365 allows you to share your cloud simulation models and data with your signal integrity team and test engineer. Read Article

Component Shortages Report from IHS What are the coping strategies available for PCB Designers to face the challenging impact of component shortages in the industry? Watch and learn in this episode with expert Greg Wood of IHS. Read Article

New Dimensions of PCB Simulation Judy Warner: What was the technology impetus behind forming Avishtech as a company? Keshav Amla: The simple answer is that we saw some major pain points in the existing electronics design and development approach, relating to signal integrity, manufacturability and reliability of PCBs. As far as signal integrity, loss modeling was a source of major consternation, but an even bigger cause for concern was the inability to predict manufacturability Read Article

How to Speed Up Your DFM Report Process in the Cloud Make sure your design will be produced with high quality and yield with our DFM analysis guidelines. You’ll want to perform DFM analysis at multiple stages during the design process. Read Article

Antipad Diameter, Crosstalk, and IBM’s Results from IPC APEX EXPO 2021 Interlayer crosstalk begins with antipad diameters, and IBM’s results help us see how antipad diameter on back-drilled PTHs affect signal integrity. Read Article

Microstrip Ground Clearance: How Close is Too Close? Make sure to account for microstrip ground clearance when using copper pour on the surface layer. We’ll examine what happens with microstrips, striplines, and coplanar waveguides. Read Article

How to Design Castellated Holes in a PCB for an SMD Module Modules on small PCBs can be quickly surface-mounted to a carrier board withe castellated holes. Here’s how you can design castellated holes. Read Article

Reinventing the Business of Electronics Altium’s Chief Ecosystem Officer, Ted Pawela, and Altium’s Chief Software Architect, Leigh Gawne, join us to give us information about the launching of Nexar—an open ecosystem with zero cost. Read Article

Complete Guide to DFM Analysis Make sure your design will be produced with high quality and yield with our DFM analysis guidelines. You’ll want to perform DFM analysis at multiple stages during the design process. Read Article

Back to Home